Open 24/7 for leaks and roof emergencies Call (929) 412-6597

Commercial roof repair

Commercial roof repair that finds the leak before it fixes it

Water on a warehouse floor or a stain over a tenant's office rarely starts right above it. We trace it to the seam, drain or flashing that let it in, fix that, and send you photos of both.

  • HoursOpen 24/7
  • NYC license2135523-DCWP
  • EstimateFree, in writing

Leaking right now

The first hour of an active leak

Inside the building

  • Move stock, equipment and anything electrical out from under the drip, and catch the water.
  • If water is near lights or panels, have a qualified person shut that circuit off.
  • Photograph the ceiling, the floor and anything damaged, with the time. Your insurer will ask.

On the roof, only if it is safe

In daylight and dry weather, a quick look for a clogged drain or a torn sheet helps. Never go up in rain, ice, high wind or the dark, and stay well back from edges and skylights.

When you call us

Have ready: the address, where the water shows inside, how you reach the roof (stairs, hatch, ladder), and who can let us in. Photos from inside and on top save time.

Where the water gets in

Six places commercial flat roofs leak

Cross-section of a flat commercial roof with six numbered leak points 123456 membrane · insulation · roof deck
Numbers match the list below. Drawing simplified; not to scale.
  1. 1

    Seams and laps

    Where two sheets meet. Heat-welded TPO seams open after years of movement; glued EPDM laps lose grip; torch-down laps lift at the edges.

  2. 2

    Drains, scuppers and ponding

    A blocked drain leaves standing water. Two days of ponding finds every weak seam nearby, and the weight can sag the deck.

  3. 3

    Flashing at walls and parapets

    The roof turns up the wall here. Cracked base flashing or loose counterflashing lets water run behind the membrane.

  4. 4

    Rooftop units and curbs

    HVAC curbs, ducts and condensate lines get stepped on during service calls, and their flashing is often the first thing to fail.

  5. 5

    Pipes, vents and penetrations

    Every pipe through the roof needs a boot or pitch pocket. Old pitch pockets dry out and shrink away from the pipe.

  6. 6

    Edge metal and coping

    Wind lifts loose edge metal and coping joints open up. Water then gets under the membrane from the outside edge.

Diagnosis

How we find the source

We walk the whole roof, not only the area above the stain. Water can travel along the deck or a beam for several feet before it drips, so we match the path inside to the likely entry point on top.

When the cause is not obvious we water-test one area at a time, check the insulation for moisture, and look at the rooftop units and their condensate lines, because some "roof leaks" are really HVAC water. Every step is photographed.

The photo on the right is a good example: an earlier patch sits over a seam that kept opening underneath it. A patch over a moving seam rarely holds; the seam itself has to be rebuilt.

Close-up of a black patch smeared over a flat-roof seam that has split open again beside it
Patch over a split seam, photographed by our crew on a flat roof in one of the outer boroughs.

Repair or more

Repair, section replacement, coating or a new roof

We are not in a hurry to sell you a roof. What we recommend depends on what the roof shows, and you see the same evidence we do.

What we findUsual answer
One leak, one spot, roof otherwise dry and flatRepair the spot and check the area around it
Repeat leaks along the same seam line or wallReplace that section of membrane and flashing
Surface worn and chalky, but insulation dryA coating may add years; we test adhesion first
Wet insulation over a large part of the roofSection or full replacement; patching traps the water
Deck soft, rotted or rusted throughReplacement including the deck (needs a DOB permit)

Thinking a new roof may be due? See commercial roof replacement. Want fewer surprises next year? Ask about scheduled inspections and maintenance.

Systems

Roof systems we repair

Most commercial roofs in Brooklyn, Queens and the Bronx are one of these: TPO or PVC single-ply, EPDM rubber, modified bitumen (torch-down or self-adhered), built-up tar and gravel, or an older roof with a coating on top. Each one is repaired with matching material: hot-air welding for TPO, EPDM primers and tapes for rubber, new cap sheet for mod-bit.

Permits and NYC rules for roof repairs

Most repairs do not need a DOB permit. The city's rule on minor work, 1 RCNY §101-14, exempts repair or replacement of the membrane, roof coverings, cant strip and insulation above the deck, as long as the Energy Code does not call for added insulation. Once the work reaches the deck or sheathing, a permit is required. Landmarks, sidewalk sheds and other agencies can still have their own rules.

Two more rules come up on repairs. Low-slope roofs normally need a reflective "cool" surface under Chapter 15 of the NYC Building Code, but that does not apply when the area being redone is under half the roof and under 500 square feet (§1511.1). And any torch-down work needs a crew member certified under FDNY G-60 on the torch, plus a fire guard. For the full permit picture, our Manhattan site has a guide to NYC roof permits.

If the roof is still under a manufacturer warranty

Check the paperwork before anyone cuts into the membrane. Manufacturer guarantees usually require leaks to be reported to them or the installing contractor, and repairs by others can affect coverage. Send us the warranty and we will tell you what we can do without putting it at risk, or who to call first.

What you get after a repair

  • Photos of the problem before we touch it, and of the finished repair
  • The cause in plain words, and anything else we saw that needs attention
  • The price in writing before the work starts
  • An invoice you can forward to an owner, board or insurer

Straight talk on warranties: small repairs come with no written warranty on small repairs. New roofs carry a 2-year labor warranty, plus a 20-year manufacturer warranty on materials.

Where we repair commercial roofs

We repair commercial roofs in Brooklyn, Queens, the Bronx and Staten Island. Manhattan building? Our sister site manhattanroofing.nyc covers it.

Between repairs, the checks in our roof maintenance checklist are what catch the next leak before it starts.

Questions property managers ask

Why does the roof only leak in the afternoon or after heavy rain?

Afternoon drips on a dry day often come from condensation or rooftop equipment, not the roof: warm air meets a cold deck, or a condensate line overflows. Leaks only in heavy, wind-driven rain usually point to flashing, walls or edge metal. Tell us when it happens; the timing narrows the search.

Who pays if the same spot leaks again after a repair?

Small repairs come with no written warranty on small repairs, and we say so up front. Call us as soon as it happens: often the new leak is a different spot nearby, which tells us the area needs more than a repair.

Can you work on the roof while the store or warehouse stays open?

Usually, yes. Repairs happen on top, so the main things to plan are access to the roof, where we park and carry materials, and any work that brings smell or noise inside. We agree that with the building first.

Will a repair void the manufacturer's roof warranty?

It can if the guarantee says repairs must go through the manufacturer or the original installer. Read the terms or send them to us before work starts.

Does a commercial roof repair need a DOB permit?

Not when it stays above the deck, under 1 RCNY §101-14. Work on the deck or structure needs one; we tell you in the written scope which applies.

Send the address and a few roof photos

We will tell you what we see and when we can be on the roof. Estimates are free and come in writing.