Open 24/7 for leaks and roof emergencies Call (929) 412-6597

Roofing systems

Commercial roofing systems for NYC flat roofs

Almost every commercial roof in this city is flat or close to it, and four families of system cover nearly all of them. Which one belongs on your building depends on the roof's size, what sits on it, how much traffic it takes and what the city rules require of a new surface.

TPO & PVC single-ply

Welded thermoplastic sheets, usually white. The default answer for a large exposed replacement because the welded seams are testable and the reflectance rule is met without argument.

Best on
Big open roofs, warehouses, roofs with plenty of equipment
Watch
Seam quality, punctures near traffic, edge detailing
TPO & PVC single-ply in detail →

EPDM rubber

Wide rubber sheets joined with tape or adhesive. Long record on New York flat roofs, but a plain black sheet does not meet the city reflectance rule on its own.

Best on
Existing rubber roofs, ballasted assemblies, exempt areas
Watch
Seams, shrinkage at corners, hidden damage under ballast
EPDM rubber in detail →

Roof coatings

A liquid layer over a roof that is still sound and dry. Extends a roof and can answer the reflectance question at the same time.

Best on
Sound roofs with good drainage and intact insulation
Watch
Wet insulation, ponding, adhesion to the existing surface
Roof coatings in detail →

Modified bitumen

Layered asphalt sheets, torch-applied or self-adhered. Tough underfoot and familiar to every New York building.

Best on
Small roofs, heavy foot traffic, patch-and-extend work
Watch
Open laps, blistering, fire safety during hot work
Modified bitumen in detail →

How the choice is actually made

Owners often ask which system is best, as though there were one answer. On a real building the decision falls out of four questions, in this order.

  1. What is already up there. The number of existing layers, whether the insulation is dry and what the deck is made of rule options in or out before anything else. A roof carrying two layers of covering cannot simply take a third.
  2. What the roof has to put up with. Grease exhaust from a kitchen, constant service traffic around equipment, ponding at a low point, or a waterfront exposure each point to a different membrane and a different detail.
  3. What the rules require. A new or replacement low-slope roof has to meet the city's reflectance values unless an exception applies, and a job that reaches the deck can bring other requirements with it.
  4. How long you intend to hold the building. A five-year plan and a twenty-year plan justify different money, and it is a fair question for us to ask before recommending anything.

We are not tied to one manufacturer; the product is chosen for each job after the survey. Whatever the system, the written scope names the product, the thickness and the attachment method, so you can compare bids on the same basis.

Systems are only half of a roof

The membrane gets the attention; the details decide whether the roof works. Drains and their layout, insulation and how it is fixed, the flashing at every wall, curb and penetration, the edge metal, and the walkway layout for whoever services the equipment: these are where nearly every leak we attend began, whatever the sheet is made of.

If you are weighing one system against another for a particular building, our guide to choosing a commercial flat roof system sets out the constraints and the lifecycle costs that usually decide it.

Start with the problem rather than the product. If there is a leak now, see commercial roof repair. If the roof is at the end of its life, see replacement. If you want it to last longer, see inspections and maintenance.