Sign brackets and raceways
Store signs are bolted through parapets and roof edges, often by a sign company years after the roof went on. Each bolt is a hole in the wall cap or the flashing.
Building types
A store roof is paid for by a landlord, used by tenants and judged by customers walking in under a wet ceiling. The work has to fit around all three: leases, opening hours and the people who live upstairs.
In Brooklyn, Queens, the Bronx and Staten Island, the city's land-use file counts more than 51,000 lots whose buildings are stores, offices, or stores with apartments above. Together they hold about 337 million square feet, and they break down very differently:
| Building | Lots | Floor area (sq ft) | What stands out |
|---|---|---|---|
| Store buildings | 16,309 | 137.6M | Half are a single story; 244 are shopping centers averaging about 110,000 sq ft |
| Store with homes above | 30,675 | 108.9M | 88% built before 1940; six in ten are in Brooklyn |
| Office buildings | 4,678 | 90.8M | Two thirds are one or two stories; 313 have 50,000 sq ft or more |
So "retail roofing" can mean a one-story strip center with a dozen tenants, a 1920s brick row with a deli below and two families above, or a two-story office building off a commercial avenue. The membrane might be the same; the plan, the people and the paperwork are not.
Queried from PLUTO on NYC Open Data (classes K, S and O), November 2026.
Typical leak sources
Store signs are bolted through parapets and roof edges, often by a sign company years after the roof went on. Each bolt is a hole in the wall cap or the flashing.
Every new tenant adds a heating and cooling unit, a duct run and a power line. On an older strip, the roof ends up with units of every age, each on a curb flashed by someone different.
Restaurant fans throw grease onto the roof around them. Some single-ply membranes swell and weaken where it builds up, so those areas need a grease guard and a separate check.
Storefront parapets and cornices face the street and the weather. Open coping joints let water into the wall behind the sign, and it often shows inside the store, not on the roof.
Many store buildings were extended to the rear. The joint where the newer, lower roof meets the old wall is a leak line on block after block.
A shopping center is one roof shared by many businesses, so the first job is finding out whose problem the leak really is. Water reported in one store regularly starts at the neighbour's unit, a drain two bays over, or a sign bracket at the front. We walk and photograph the whole roof, mark each finding on a plan, and the landlord gets one report covering every tenant space. That also makes it easier to charge a repair back to a tenant whose installer caused it, where the lease allows.
When a strip center's roof is worn out, replacement is phased by tenant: sections closed up each day, deliveries of material before opening, and the noisiest work kept off the busiest trading days. White single-ply sheets suit these large flat roofs and meet the city's reflectance rule as installed; see TPO and PVC roofing.
The prewar mixed-use building is the backbone of commercial streets in Brooklyn and Queens: more than 30,000 of them across the four boroughs, nearly nine in ten older than 1940. The landlord is a business, the ground floor is a business, but the roof is over somebody's bedroom. These roofs tend to have layers of old roofing, short parapets with tired coping, and a rear extension with its own lower roof. Before any recover we check how many layers are already there, because the Building Code does not allow a new roof over two existing coverings. For the resident side of the job, see apartment building roofing.
Most office buildings outside Manhattan are one or two stories: medical offices, professional buildings, small headquarters. Their roofs carry more equipment than you would expect, because every office floor needs cooling, and telecom gear often shares the roof. The usual issues are curbs and penetrations rather than the field of the roof, and the main constraint is noise during working hours.
Sources: 1 RCNY §101-14 · Building Code chapter 15 · historic district and landmark flags from PLUTO.
We work across Brooklyn, Queens, the Bronx and Staten Island and are usually on site for a leak in about 2 hours. Price is set after a visit, since the building's location, how materials get up to the roof, how debris comes down, the space around the building and the roof's condition all change the job; the cost guide gives the range we work from.
The lease decides, and it differs. Net leases often pass roof upkeep to the tenant, while many store leases keep the roof structure and membrane with the landlord. Read the repair and maintenance clauses, report the leak in writing either way, and make sure whoever signs our written price is the party the lease makes responsible.
Yes, in nearly every case. The work stays on the roof and is phased so each section is closed up the same day. Loud tear-off, crane lifts and anything with fumes are scheduled before opening or after closing where needed, and the landlord or manager tells the tenants which days are affected.
Yes. On a store with homes above, the roof is over the apartments, so the work is planned around residents as well as the shop. The landlord usually approves the scope; we agree access, hours and notice with them. Our apartment building page covers the resident side in more detail.
A written scope and price, photos of what we found and what we did, and our license and insurance papers. If your company or the owner must be named on the certificate, we can name your company as additional insured on our certificate, usually within 1 day. See our credentials page.
We will tell you what we see and when we can be on the roof. Estimates are free and come in writing.